6FC5203-0AF05-0AB1 Siemens OP015A Keypad Membrane

Order each part separately is available

Front and rear side of 6FC5203-0AF05-0AB1 Operator Panel Keypad
The front interface is USB 1.1 to connect an external keyboard or mouse. Note that the electromagnetic compatibility of commercially available peripheral devices operated via the USB port of 6FC5 203-0AF05-0AB1 is usually rated for office use only. For industrial use, components with a higher degree of certification are recommended. The rear interface of Siemens 6FC52030AF050AB1 Membrane Keypad has two cables for connecting the PCU: I/O USB cable K1 (ribbon cable): All signals that are used for the display interface and the connection of operator panel fronts (e.g.supply voltages) and Display cable K2.

Preparation for mounting of 6FC52030AF050AB1
Thanks to the tension jacks on the OP 015A 6FC5203-0AF05-0AB1 Membrane Keyboard, drill-holes or screw holes are not needed. This retaining method also affords a degree of protection IP65 (but only in conjunction with a circumferential seal and when the protective USB cap is fitted). If you want to combine the OP 015A 6FC5 203-0AF05-0AB1 Membrane Keypad Switch with a PCU and possibly a direct control key module, assemble the components before installing them on the mounting wall.

Mounting Siemens 6FC5203-0AF05-0AB1 Terminal Keypad on the mounting wall
The clearance at the rear of the PCU must be at least 10 mm to ensure sufficient ventilation. Permitted mounting position: deviating by up to 5 from the vertical. This value can be further restricted by installed components of 6FC52030AF050AB1 Operator Keyboard (PCU, video link receiver,...).